Guitar and Bass

Green 2
Today we had a 2 hour recording session focusing on guitar and bass again. We tacked lead guitar,
some textural guitar parts before re-tracking bass. The set up was very similar to the last recording
session, using a fender telecaster in to an orange amp. For the textural parts we added in delay and
reverb from DD7 and Polaris pedals respectively. The guitar signal went straight into a DI box, the
output going into the mixing desk and the link going over to the pedal board then into the amplifier.
The microphones used were the same as for our last guitar session, a Royer R121 and an SM57.

We just recorded direct signal from the bass, on Friday we will reamp that signal. We used a Fender
P Bass for this song and tracked the DI with a small amount of compression and EQ from the LA2A
and Pulec EQ. We didn’t go too over board with this step so we would have a relatively clean signal
to amplify later.

Finally, we made a small wave form edit to one of the drum fills bringing it in line with what we
expected to hear.